Complete Operation Sawmill

The seller has confirmed that this whole operation was in good working/running condition when pulled from service. It is all packaged and ready to load! - Morgan Sharp chain scragg mill - 40" circular insert tooth saws w/ 125HP electric motor w/ soft start and hydraulic drive - Hydraulic log step feeder - (3) saw chain feed trim saw - 7HP on each saw - 2HP drive - Cornell double arbor Gangsaw: 75HP bottom motor - Pineapple feed w/ infeed and outfeed powered rollers - Baker Bandsaw resaw - 4 cut - (2) 40HP electric motors - Timberland sidewinder board deduster - 30' (2) strand log deck - Lots of extra parts and saw blades included - No take away belts. Slabs drop on to a crossover belt. - It's NOT the mini scragg. It has 40" saws and machine is over 20' long x 8' wide, per seller - Double Arbor This is currently set up for short logs, but if you remove the hold down wheels that he placed on there, you will be able to take a log up to 12'. This would be a great setup for a small diameter log (4" to 12") averaging a log every 5-6 seconds. These folks were averaging 14,000 bdft per shift sawing 5/8 deck boards with a crew of (5).