Ambition 1440 FC

Machine ID: 007426

Year Mfr: 2014

Condition: Good Condition

Location: North

Voltage: 230/460V, 60Hz, 3Ph

Contact: Ralph Viegelmann
704-288-1904 Ext: 101
Submit an Inquiry on this product

This machine was installed new in 2016 and is being replaced by a larger unit with more features.

  • Edge band thickness: 0.4 - 8 mm
  • Coil cutoff maximum: 0.8 x 60 mm, 3.0 x 45 mm (PVC)
  • Edgeband height: 12-65 mm
  • Panel length: Min 160 mm
  • Panel width: Min 70 mm
  • Panel thickness: Min 8 mm, mx 60 mm
  • Edge height = panel thickness: +5 mm
  • Feed speed: Variable: 8-14 m/min, 3 HP motor
  • Premill
  • Corner Round
  • Joint trimming unit: (2) Motors (3 HP each), 12,000 RPM
  • Pressure section: First roller driven, two rollers idle
  • End trim unit: (2) Motors (.5 HP each), 12,000 RPM, 360 square mm
  • Fine trim unit - auto tilt: 3/4 HP Motor, 12,000 RPM
  • Contour trimming unit: .5 HP, 12,000 RPM
Machine Features
Motorized top pressure beam for panel thickness adjustment
Smooth top pressure rollers
Automatic feed track lubrication system
Adjustable infeed fence with servo motor control
Panel pre-heater
Pneumatically-controlled hard stop at machine in feed to prevent premature panel introduction
Joint trimming unit for pre-trimming the work piece edge prior to processing
** IMPORTANT NOTE **  Although this machine is capable of running thicker panels, the pre-mill cutter heads on this machine are only 42 mm working height!  If pre-milling of panels thicker than 42 mm is desired, please obtain an alternate quote which includes 60 mm working height pre-mill cutter heads.
Quick melt granulate glue application system
Quick-change glue tank for easy maintenance and glue color change, if necessary
Motorized positioning of the pressure zone.  First pressure roller driven and two idle pressure rollers
Double motor end trimming unit with straight and chamfer capability.  Chamfer up to 15∞.  Program controlled indexing from straight to bevel end trimming
Multi- stage fine trimming unit with 3 working positions: profile 1, profile 2, flush trimming.  Auto tilt and servo controlled horizontal tracing rollers for edge thickness
Contour trimming unit for profile corner trimming
Multiple radius scraping unit with program control for two different radii with servo controlled vertical and horizontal tracing rollers
Finish scraping unit
Buffing unit with 2 motors, 0.18 kw each. 2 cloth buffing discs, dia. 150 x 20 mm
Electronic frequency changer for all trimming motors
Isolation transformer with variable in feed voltage for balancing all three phases of incoming power.  This transformer will increase the lifetime of the machine’s electrical components.  Also helps dampen power surges and cancels line noise

Manufacturer Brandt
Model Ambition 1440 FC
Year 2014
Voltage 230/460V, 60Hz, 3Ph
Machine Location North