Machine ID: 007391

Year Mfr: 2007

Condition: As Taken From Service

Location: Southeast USA

Voltage: 230/460V, 60Hz, 3Ph

Call For Price
Contact: Ralph Viegelmann
704-288-1904 Ext: 101
Submit an Inquiry on this product

This machine has low hours.  The current facility is not running the bander at this time.

Manufacturer specs (to be confirmed):

  • Although the machine is capable of running thicker panels, the pre-mill cutter heads on this machine are only 42 mm work height.
  • Universal automatic magazine for strip and coil feeding.
  • Large coil table
  • Quick melt granulate glue application system with 12-minute heat up time.
  • Quick change glue tank
  • Strengthened precutter for cutting PVC
  • Double motor end trim unit with straight and chamfer capability. Chamfer up to 15 degrees. Program controlled indexing from straight to bevel end trimming.
  • Fine trimming with servo motor program controlled indexing.
  • Contour trimmung unit
  • Scraping unit for rigid PVC edges.  Program controlled indexing.
  • Buffing Unit
  • Electronic frequency changer for all trimming motors.
  • Joint triming unit: Pretrim of the piece, 2-motors, vertical spindle adjustment, horizontal positioning
  • End trim station
  • Fine trim unit
  • Contour trim unit
  • Scraping unit with knives
  • Top and Bottom buffing unit
  • Premill
  • Corner Round
  • Edgeband thickness: 0.4-12 mm
  • Edgeband height: 12-60 mm
  • Panel Length min: 160 mm
  • Panel width min: 65 mm
  • Panel thickness: 8 - 55 mm
  • Feed Speed: 2-Speeds 16 m/min and 11 m/min
  • Feed motor: 3 HP
  • Joint trim unit: 3 HP
  • End trim unit: (2) 1/2 HP
  • Fine trim unit: 3/4 HP
  • Profile trim unit: (2) 1/2 HP
  • Machine length: 19'
  • Machine width: 6'
  • Approx wieight: 5,000 lbs

Manufacturer Brandt
Model KDF-650C
Year 2007
Voltage 230/460V, 60Hz, 3Ph
Machine Location Southeast USA