KAL 310-A20-S2-CNC

Machine ID: 007028

Year Mfr: 2004

Condition: Good Condition

Location: Southwest USA

Voltage: 480V, 60Hz, 3Ph

Contact: Ralph Viegelmann
704-288-1904 Ext: 101
Submit an Inquiry on this product

This machine has been checked by a technician and is in good working condition.
-Working level: 950mm (37 13/32")
-Minimum working width with 22mm (7/8") thickness: 55mm (2 5/32")
-Minimum working width with 60mm (2 3/8") thickness: 100mm (3 5/16")
Panel overhang: 30mm (1 1/8")
-Minimum workpiece thickness: 12mm (15/32")
-Maximum workpiece thickness: 60mm (2 3/8")
-Edge thickness strips: 0.4-20mm (0.16-25/32")
-Edge thickness coils: 0.3-3mm (0.12-1/8")
-Processing limits, strips: 900mm2 (1.39 sq.in)
-Processing limits, coils: 135mm2 (0.19 sq.in)
-Variable feed speed: 18 to 24m/min (59 to78 ft/min)
-Amperage service: 80A
-Control voltage: 24V
-Dust extraction;
-Mim. air velocity: 28 m/sec (92 ft/sec)
-Static pressure: 200 mm/ws (7.87"/ws)
-Air volume: 7980 m3/hr (4696 cfm)
-Compressed air;
-Connection size: 3/4"
-Pressure required: 7 bar (100 PSI)
-Adjustable in-feed fence
-Pre-milling unit (#3481) with two (2) motors 3kW, 9000 RPM for maximum tool diameter of 125mm (4 15/16").
-Noise projection stepped (#0424)
-Panel pre-heater (#2325)
-QA 34 quick melt gluing unit (#2123)
-Glue roller drive (#2141)
-Clamping device for glue pot (#2143)
-Glue container back-off (#2145)
-Multi-purpose magazine
-Magazine for six (6) rolls (#2458)
-Clipping unit (#2445)
-Magazine height adjustment (#2460)
-Pressure zone for gluing section Type C (#2507)
-CNC stepless axis for edge thickness adjustment (#2596)
-Snipping unit HL 05 (#3054)
-Adjustment chamfer, straight (#3114)
-Top and bottom flush trimming unit (#3209){Top and bottom rough trimmers}
-Set of TCT rough trimming cutters "I" system (#3900)
-Adjusting device - penumatic (#3251)
-Automatic multi-trimming unit (#3220) {Top and bottom tilting fine finish trimmers}
-Set of diamond cutters multi trim "I" system (#3930)
-Profile triming unit FF 12 (#3503) {4 motor corner rounding}
-"I" system diamond cutter R=3 T=4 (#3919)
-Pneumatic adjustment for profile trimming unit (#3536)
-Open space (#4511)
-Noise reduction enclosure (#0415/0425)
-Profile scraping unit (#4510)
-Pneumatic adjustment for profile scraping unit (#4522)
-Top and bottom edge buffing unit with oscillation (#4402)
-Electronic height adjustment (#6275)
-Electronic control with programmable memory (PLC)
-Monitor input NC 21 (#6313)
-Includes a 2nd glue pot

Manufacturer Homag
Model KAL 310-A20-S2-CNC
Year 2004
Voltage 480V, 60Hz, 3Ph
Machine Location Southwest USA